Then I crossed over toward the door.Īt this point I based much of the rest of my installation on this helpful video. I lightly used some electrical tape to stick the wire to the rest of the wires in there, and ran them down below the airbag. So instead I followed this video and pulled the trim piece off at the top. This could impede the path of an inflating curtain airbag, and potentially very unsafe. I've seen videos where people just stuff the wire behind the A-pillar trim, and then down the side behind the weatherstripping. I used the plastic pry tool they included with the camera to shove the wire up above the Eyesight camera housing and the headliner, all the way to the A pillar. Using my hardwire kit, which has the right angle mini-USB connection on one end, I ran the wire up along the mirror wires, then left toward the drivers side along the top. I got as close as I could to the shading dots at the top there. What I decided, and so have many others, is that directly behind the rear view mirror is the safest location that is within the wiper blade path. You don't want to put the camera in the field of view of the Eyesight cameras because it can interfere with their operation. I have Eyesight in my 2017 Forester, which makes placement a bit tricky. If frowned upon, feel free to remove the links.) (Note: I promise I'm not a shill for them, I just wanted to be thorough and helpful by sharing as much information as possible. No need to splice, solder, or jerry rig a bunch of adapters like many of the writeups and videos I saw have. They also sell a $30 hardwire kit (NBDVRS2HK) that makes it dead simple to perform this procedure. I went with the Wirecutter top pick Nextbase 522GW, which I found on Black Friday sale at Best Buy for $195 (normally $260). My main goal was to hardwire my new dashcam to the fusebox, and to properly and safely hide all the wires. I did not find any single page or post that answered all of my questions, though this video has almost everything you need to know, so I'll provide a write up to hopefully help someone in the future I like to know exactly what I'm getting into before I get started. I'm fairly technically adept, but by no means an expert with cars or electronics. I spent a lot of time searching on Subaru forums, Subaru subreddits, Youtube and general googling.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |